Skip to content
LongPoint Garage Door Experts
Open 24/7(226) 641-6371Open 24/7
Person kneeling inside a garage reaching up along the vertical track of a white paneled door, with a toolbox and drill nearby. — Garage Door Cable Replacement, Gilbertville
Gloved hand holding a white garage-door roller beside its track, with two loose rollers and a red tool on a tray. — Garage Door Roller Replacement, Gilbertville

Springs · Gilbertville

Garage Door Cable Replacement in Gilbertville

Standing inside with the door closed, you notice the cable on the right side near the floor has gone fuzzy.

Call (226) 641-6371

In plain words

Winter is hard on the bottom of a garage door. Slush and road salt run off the car and pool exactly where the cables loop onto the bottom brackets, and wire rope that is wet and salted for four months a year rusts from the inside out. Snow packed under the door can also stop it short, letting the cables go slack and slip their drums. Cable replacement puts fresh galvanized cable on both sides, cleans or renews corroded brackets and resets the balance, and the technician can show you how a clear threshold and a light coat of lubricant carry the new set through many more winters.

Sound familiar?

Your older door has springs along the tracks, and one cable has slipped off its pulley and dangles slack. The door lifts crooked and needs a shoulder to close, when it used to glide.

How the visit goes

Garage Door Cable Replacement

How the visit goes

Paneled garage door leaning on its side against a wall, with one section on sawhorses and a tool bag on the floor. — Gilbertville
Technician in a cap fastening a small black plastic housing to a white frame beside a glass door, with a screwdriver. — Gilbertville
  1. Bottom brackets and the pin the cable rides on

    The bottom bracket in each corner anchors the cable and carries the bottom roller, and it lives in the wettest, saltiest spot on the door. The technician looks for bending from an impact, corrosion around the cable pin and the fasteners into the section, and a roller that has seized or lost its stem bearing. On many doors these brackets have tamper-resistant fasteners because they are under load whenever the springs are tensioned, so they are inspected as found and only removed once the counterbalance is unloaded. A bracket that is bent or rusted through is scheduled for replacement in the same visit so the new cable has a sound anchor.

  2. Setting the door level

    Before any spring tension returns, both cables are brought to the same tension. The technician rotates each drum until the slack is gone and the cable is snug in its groove, then tightens the set screws onto the shaft, often onto a small flat so the drum cannot creep. A level on the top section confirms the door sits square in the opening, and the gap under the bottom seal is checked along its length. If one corner sits high, the drum on that side is eased and reset. This is the moment that decides whether the door will run straight for years, so it is not hurried.

  3. Keeping salt and slush off the bottom hardware

    The new cables will last longest if the bottom brackets stay reasonably dry. Through winter, push slush away from the door's inside edge rather than letting it pool against the bottom section, and wipe the road salt off the brackets and the lowest stretch of cable when a mild day comes. A light spray of silicone lubricant on the cable loops and bracket pins in late autumn sheds meltwater. Park so the car does not drip directly onto the corners of the door. None of this is a chore, and it addresses the one spot where cables in this climate almost always fail first.

Garage Door Cable Replacement

In the van

  • Winding bars

  • Cable drums, matched pair

  • Drum set screws

  • Bottom brackets with cable pin

  • Extension-spring pulleys and sheave forks

Technician in a black beanie fastening a hinge plate to a white door with small windows using a yellow cordless drill. — Gilbertville

Garage Door Cable Replacement

What affects the quote

  1. Springs found weak or broken

    If the inspection shows a spring that is broken, stretched or wound short, replacing it is explained and priced separately from the cable work, and the two are done in one visit if you agree.

  2. Condition of the bottom brackets

    A bracket bent by a bumper or corroded by years of salt is replaced while the system is unloaded. New brackets, roller and fasteners are listed as their own line.

  3. Drums that need replacing

    Worn grooves, a cracked slot or a drum that has spun on the shaft mean a new pair of drums, which adds parts and a little time to the same visit.

What to have ready

  • Is the door sitting level, or is one corner higher than the other?
  • Is there rust on the cables or brackets near the floor?
  • Does the opener still run, and does it strain or reverse?
Call (226) 641-6371

Garage Door Cable Replacement: questions

Questions
What is the cable drum, and when does it need replacing too?

The drum is the grooved wheel on each end of the torsion shaft that the cable winds onto as the door opens. Its grooves guide the cable in a single layer and its shape sets how the door is balanced through its travel. A drum is replaced when the grooves are worn or cracked, the cable slot is damaged, or it has spun on the shaft and scored it. Drums are changed in pairs.

What information helps when I call?

Whether the door is sitting crooked, jammed partway or on the floor; whether you can see a cable hanging loose, frayed or wrapped around the shaft; whether there is a spring above the door or springs along the tracks; the door's rough height and whether it is a single or double; and what happened just before, such as the door coming down on something. A photo of the drum end and the bottom corner is useful.

What makes a cable fray?

Fraying is individual wires breaking, and it comes from two things: bending fatigue where the cable wraps the drum or pulley, and rubbing where it touches something it should not, such as a bent track edge, a rough drum groove, a seized pulley or a bracket sitting crooked after a bump. Corrosion speeds both. The technician looks for the rough edge so the new cable does not meet it.

Related services

Garage Door Cable Replacement near you

Call(226) 641-6371

Request a visit

Or call (226) 641-6371 · open 24/7