
Springs
Springs & Hardware
Heavier doors, such as insulated steel or wood, need springs with more capacity, and a door that has been reskinned or insulated since its springs were fitted may be undersprung without anyone knowing. We check the match and correct it.



Which one do I need?
- Halfway up, the door hesitates and the opener strains before it carries on.Garage Door Roller Replacement
- Pressing a hand against one of the middle hinges makes it rock on the panel.Garage Door Hinge Replacement
- The garage floor has settled at one corner, and the door now scrapes the concrete on that side while daylight shows at the other.Garage Door Track Repair or Replacement
- Standing inside with the door closed, you notice the cable on the right side near the floor has gone fuzzy.Garage Door Cable Replacement
- After pulling the red release cord, you tried lifting the door yourself and it would barely leave the floor.Torsion Spring Replacement
- The home inspector's report on the house you are buying flags the garage door: extension springs with no safety cable running through them, coils showing rust, and a door that sank when he lifted it partway.Extension Spring Replacement
Springs & Hardware
Counterbalance, track, roller, cable, and hinge work.







Garage Door Roller Replacement
Track straightness and roller clearance
The vertical tracks are checked for plumb and the horizontal tracks for level and for sag at the rear hangers. The technician sights along each track for dents, spread or pinched edges, rust scale and the debris that collects in the bottom few inches. Clearance matters too: a wheel should turn freely with a little side play, neither squeezed by a track pulled too close to the door nor so loose that the door can lean.
Where the track has drifted, the jamb brackets are adjusted before new rollers go in, because fitting fresh wheels to a crooked track simply wears them the same way the old ones went.
